Swerving off the road: Why are pilots avoiding EMAS?

By Chris Shieff

15Shares



Across the US alone, over one hundred runways at sixty-nine airports have a safety critical system fitted to help prevent a major cause of aviation accidents – runway overruns.

It’s called EMAS, or ‘Engineered Materials Arresting System’, which is a technical of way of using drag to safely stop an airplane when all else fails. And better yet, it has your back in all runway conditions – water, snow, ice, you name it. It’s a proven life saver.

But the problem is there are still accidents happening where pilots have actively avoided it, instead choosing to veer off the runway.

Why?

IFALPA recently put out a new position paper which may provide some solid clues. And along with work that others have done, the reasons seem to fit into one of two camps:

  • Knowledge about what EMAS is and does.
  • In the heat of the moment, pilots just didn’t know it was there.

For such an effective safety system that protects crew, passengers and even those on the ground, is it possible that we’re just not giving it the attention it deserves?

Let’s tackle both camps.

EMAS 101

Dip into the regs and you’ll see that the US FAA requires all airports to have runway safety areas. They are typically 500 feet wide and extend 1000’ past the runway end, and are clear of obstacles in case an aircraft either overruns, or undershoots. Sounds safe, right?

But what if there isn’t enough space? Take KMDV/Chicago Midway for example. It’s not always practical. That’s where EMAS comes into it. It achieves a similar level of safety, only using a lot less room.

In a squeeze – Chicago Midway where EMAS is installed. Courtesy: Chris Bungo

It is essentially a concrete bed (or ‘arrestor pad’) of increasing depth which contains thousands of blocks of crushable material that are designed to quickly slow down an aircraft with little or no damage – likely your nose wheel, and that’s about it.

And it works really well too. In fact, it’s so effective it can stop an aircraft travelling as fast as 70kts – which is a good thing as 90% of all overruns happen below this speed.

It’s not even a big deal to replace it – it’s modular. Only the blocks that have been damaged need to be changed out.

Grass and dirt.

Some EMAS pads are only 150’ long. When faced with obstacles like trees, buildings, and roads it’s no wonder that the instinct is to avoid ploughing straight ahead.

Instead, the grass and dirt off the side of the runway begins to look like a very appealing option to slow an airplane down. And as the FAA itself once phrased it, ‘there’s a myth that if you take the dirt, you won’t be on the news…’

But the reality is that EMAS will do a far better job and with a safer outcome and less damage.

What about approach lights?

Lights on an EMAS arrestor pad are designed to break away and do very little damage to your ride.

You may not know it’s even there.

This is where IFALPA get really stuck in. Some crew actively steered away from EMAS simply because they didn’t know, or forgot, that it was there.

Knowledge is one thing, but you can’t brief what you can’t see.

Yellow chevrons indicate an EMAS arrestor pad, but there is no standardised signage in place for it. Take a look a look again at the list of US airports with it installed – if you operate in and out of any of them, how often are you thinking about EMAS?

If you hadn’t briefed it, would you know it was there?

And the story doesn’t end with signage either. What about approach and airport charts? Leading chart manufacturers indicate where EMAS is present on ground charts only. But not on approach charts – the argument is that it won’t fit.

IFALPA has suggested how EMAS might be shown on an approach chart Couresty: IFALPA.

It seems as though the work hasn’t been finished just yet. EMAS is really effective, but as an aircraft departs the runway, there just isn’t enough time to figure out it’s there or not. And that all starts with crew awareness with the tools available when ops are normal.

Regulators in the US and abroad need to be doing more to illuminate this valuable piece of safety tech. At least five hundred lives have already likely been saved because of it.

Knowledge is power.

Which is certainly the case with EMAS. Combine both camps, and pilots (myself included) can understand how valuable an obscure sign that says ‘EMAS’ may be, and also know when it is available before you need it the most.

Only then will it live up to its full potential.


More on the topic:

More reading:

Chris Shieff

Chris Shieff

OPSGROUP team member and A320 pilot. Based in sunny Auckland, New Zealand. Question for us? Write to blog.team@ops.group.

7 Comments

  • Jose Bachiller says:

    FAA AC 150/5345-39E specifies the markers required for EMAS

  • JR. Bob Dobbs says:

    Just a note that yes, yellow chevrons can indicate an EMAS arrestor pad, but there are also runways with yellow chevrons and no arrestor pad. It would be nice to have markings that are ONLY used for EMAS.

  • John says:

    Excellent article! I don’t remember the last time we/crew specifically addressed and briefed the presence of EMAS for a given departure. As a direct result of your highlighting… all of our future takeoff briefings will address whether or not we have it available and what actions can be expected should we have an RTO.

    • Chris says:

      Thanks John, really pleased to hear you found the article useful and I hope it plays it part in keeping you and your team safe. I appreciate the feedback!

    • Steve Smith says:

      I agree that EMAS needs to have a distinctive marking visible to pilots approaching the EMAS bed in an overrun, aborted take off.

      Yellow chevrons are used for airborne recognition of (this is not a landing surface).

      How about BLUE chevrons ( any color that could identify the area as EMAS).

      • Chris says:

        Hi Steve, thanks for taking the time to leave a comment. I agree – and very valid points. Blue chevrons, or some other distinct feature that identifies it would be an important step forward. I think also making EMAS pads highly visible on aerodrome and SID charts so it is actually briefed should be prioritised too. I appreciate the feedback!

Leave a Reply to Jose Bachiller Cancel Reply

Copy link
Powered by Social Snap